Hello
My configuration is this:
two cameras on scope(s) to an outside USB hub. (main camera-main
scope/guide camera-guide scope)
EQMOD to the USB hub to control telescope mount.
route USB3 hub 3m inside to laptop on one USB connection and connect to
ASCOM hub (EQMOD hub)
CdC planetarium program connected to ascom hub to control scope for
initial set-up.
PHD2 guiding to ASCOM hub
SGP to ascom hub to provide main camera control.
This seems a reasonable configuration - or did so until the last couple
of days. I see no alternative but I am always ready to try something else.
very grateful for any advice.
Lawrence