The pdf document explains thoroughly how to set up the software (both SkySafari and the WifiScope pieces) but doesn't say a thing about how to actually make the connection between the laptop, iOS device and the mount. I have the serial cable attached to the mount, and it's talking to WiFi Scope just fine...when I select "connect" on the Skysafari app, I'm greeted with a warning message that I need to check that I've turned on the SkyFi device in order to connect wirelessly to it. I know I must be missing something obvious...
The landing page says... ....."Simply connect your scope to WiFi Scope and then connect SkySafari to WiFi Scope and enjoy awesome telescope control right in the palm of your hand...literally!
Bottom line, how do I make the connection happen (after setup is done...?)