I have noticed that sometimes PlateSolve2 will not launch. Always on starting SGP, PlateSolve2 does load (when using the autocenter), but sometimes on meridian flip, the platesolve frames downloads but then it gets stuck and never launches PlateSolve2. Any idea why this might be? Both SGP and the PlateSolve2 binary in the SGP install directory have been set to run as admin.
Pinpoint (Full version) also seems to demonstrate the same behavior.
I am running 2.5.1.17 and Windows 10.
On that note, if a light event in a target ends up going to multiple nights (because clouds rolled in etc.), it would be nice to have "Slew" and "Center" options be available on resume. Right now this seems to be only on target start.