Update - I ran another sequence last night with 2.5.2.1 and everything worked, The only issue I'm having besides the mount not wanting to converge during centering is the Flat panel turns on but does not turn off.
My imaging run finishes up at 4 AM and I have it set to park the mount and begin doing the calibrations with Flats being the first follow by Bias and finally Darks. The flats start at 4 AM and finish up at 4:15. I look through the log and found the flat box turns on at the expected time of 4 AM but is not told to turn off until 4:58. I'm not sure why or whats so special about 4:58 but I would think the flat box would be told to turn off after all the flats have been taken or until the allotted time has expired.
Anyway I attached the log file. If you look at 4 AM you see the lightbox being set to 5 and turning on. it is not told to turn off until 4:58 as per the log. But even then when i wake up in the morning I find the panel is still on.
Attached is the log file from last night. I had to remove some of the text to get the file under the 1024 limit.
mahaffm SGPro Log from 9-12-16.txt (635.0 KB)
Regards,
mahaffm