I just wanted to bring this up again with the issue of the Alnitak light box not turning off after the sequence finishes. Maybe I don't have something configured correctly but for whatever reason, after the sequence completes taking the required flats the Alnitak flat panel is not given the command to turn off. As per the attached log, at 4:00:01 AM the Alnitak Flat box is told to turn on, setting brightness 5, but is never told to turn off. When I wake up in the morning I need go into the sequence and set the brightness to 0, As per the log this occurred at 4:50:43 AM.
Alnitak
Flat.txt (461.7 KB)
Thanks,
mahaffm