OK, well... there is no smoking gun in the logs, but this is what I think happened:
- Sequence is running and attempting to center on a target
- Sequence fails to plate solve with PS2 and terminates the sequence
- You attempt to manually plate solve a frame with Astrometry.NET and this fails
- You attempt to manually plate solve a frame with Elbrus, but it is not set up correctly and fails
- At 20:27:54 all equipment is disconnected from SGPro
- SGPro never crashes and is terminated (seemingly) normally at 16:43:45
The primary issue seems to be that your solves are failing. I can't be sure exactly why, but I have some suggestions:
- You do not have a blind solve failover setup. I highly recommend installing and using ANSVR for this.
- You are not using SGPro's sequence recover option. This is handy and gives your sequence more chances to carry on of failure is due to the environment.
- Upgrade to SGPro 2.5.2 beta to solve a serious failure on target centering
- Figure out why PS2 is not solving for you. Is this accurate?
[25/09/2016 20:19:39] [DEBUG] [Telescope Thread] PlateSove2 Param: Width - 696
[25/09/2016 20:19:39] [DEBUG] [Telescope Thread] PlateSove2 Param: Height - 520