Quantcast
Channel: Main Sequence Software - Latest posts
Viewing all articles
Browse latest Browse all 52138

Add exclude center to autofocus (in same pane as "crop auto focus frame")

$
0
0

Hi Mads,

no I cannot do that - I didn't make any tests. I just followed the advice. As the explanation from the venodor was reasonable for me and the results by following the advice were good I didn't make a question mark over it.

So I have to admit that my vote for the request, was a "vote in the dark".

May be the advice of my vendor (and also the explanation on Starizona) for focussing off-axis is only applicable, if you use a single star for focussing, but if you use a lot of starts it is not required that all these stars are in a certain area.
To be honest I did not think of that to much.

As I mentioned in my first post in this thread I am still using the single focussing method (with a Cuzdi mask), but I have planned to test out the auto focus routine of SG Pro the next possibility (free time matching clear skies).

And also for me "multi camera support" would be more valuable than this (only potential) improvement of the auto focus. But I am not sure if I should start to examine each new feature request under the aspect, if this request might prevent or delay the implementation of a much valueable feature, before supporting a request which I also would like to see.

Best regards

Reinhard


Viewing all articles
Browse latest Browse all 52138

Trending Articles