The set point temp is not being reported correctly. When cooling down the temp reading never goes below 0, even though i have it set to -5C. The ambient temp is 70 deg, testing in the house. Both Maxim Dl and Artemis Capture both work fine for the temp cooling, so it is not the camera. Also I have another Atik camera 428EX and it has the same problem in SGP. I believe the camera is cooling to the correct temp but for some reason not being reported. I never had this problem in the past. I did install the lastest core software from Atik. I will contact Atik to see if is an ASCOM problem. any help would be appreciated.
Ed Stuckey
I have SGP 2.5.1.16 installed
Here is the ASCOM camera log if that is of any help.
ASCOM.Atik.1344.404360.txt (134.7 KB)
