Correct cool down temp not report for Atik 460EX

Chris,
Sorry about the log. The ASCOM driver version is 7.0.1.38091 by Chris Rowland. I did contact Atik today, waiting for a reply.
I retested and here is the is the current wierd situation.
I connected the camera in SGP, clicked on setup,which brings up an ascom dialog box in which to enter cooler on andset the setpoint,there are also boxes for cooler power and CCD temp. SGP temperature setting ,I set to -10C in 6 min. and warmup10C in10min. Program set to begin cooldown upon camera connect. Camera begins to cool but ccd temp inthe temperatue window never goes below 0. However if I click the setting box next to the camera connect and bring up the Ascom camera settings and in the setpoint window it reflects the ccd temp. Close window,wait 30secs, click on settings and it again reflects the ccd temp in the setpoint box. After the ccd has cooled to -10C,the SPG temperation dialoge box shows 0C even though it I set to-10C.Check the settings window again and it says -10C in the setpoint box.The warm updoes everything in reverse.
So, the camera is properly cooled and warmed but not reflected in SGP or the fits header.
This is really strange.
Ed